Introduction:

Many supermoto riders face the challenge of correctly installing LED indicators or headlights and ensuring that everything works reliably.

In this article, we show step by step how to install plug & play LED turn signals, which resistors are needed, and how to avoid typical problems.

1. Why Plug & Play resistors are important

LED turn signals require resistors to blink correctly. Without resistors, rapid blinking, error messages on the on-board computer, or irregular blinking may occur.

Our mini LED turn signals for KTM, Husqvarna and GasGas models from 2014 onwards include the necessary plug & play adapters. Minor adjustments to the connectors may be required for other models.

Mini LED indicators Plug & Play KTM, Husqvarna, GasGas

Mini LED Teardrop Turn Signals, Plug & Play Version for KTM, Husqvarna, GasGas

2. Step-by-step installation of the LED turn signals

1. Remove old turn signals – carefully disconnect the plug connections
2. Plug & Play adapter – connect resistors, no soldering required
3. Install new turn signals – check the position and tighten the screws.
4. Function test – check the front and rear turn signals, retrofit resistors if necessary.

No tools like insulating tape or screwdrivers are needed – everything is ready to connect.

3. Typical problems and solutions

Problem: Turn signal flickers

• Cause: Missing or incorrect resistance
• Solution: Use plug & play resistors

Problem: On-board computer displays error

• Cause: LED too low a load
• Solution: Use resistors or load-adapted turn signals

Problem: Turn signal not working

• Cause: Incorrect plug connection
• Solution: Check connections, adjust adapters if necessary.

4. Bonus tips for LED headlights

• Clean the plug contacts before installation to prevent corrosion.
• Check that the 12V supply voltage is correctly applied.
• LED headlights are sensitive to moisture – check for condensation regularly during longer journeys.

KTM LED headlights

LED headlights for BETA

LED Headlights GasGas

and other models...

5. Conclusion

Our Plug & Play Mini LED indicators and resistors can easily equip most supermotos from 2014 onwards.

Installation is simple, safe, and requires no soldering. For added peace of mind, check the connectors on non-standard models and adjust the adapters accordingly.

Explore our complete lighting and electrical category and find the right set for your bike.